Skip all-purpose cleaners when you clean, which can do more harm than good, for something even more mild or specialized. And, as already mentioned, never wipe down plexiglass with a dry cloth, or brush over it with a bare, dry hand. It’s prone to scratching and tends to hang on to scented solutions used on its surface. For all its conveniences, plexiglass is a sensitive material. Always remember: The less pressure, the better.Ībove all, as you care for your plexiglass, be sure to avoid the three A’s: ammonia, abrasives, and aromatics. If it’s possible to simply run water over the surface without causing a slip hazard-for example, by spraying a shower nozzle on a low setting on the inside of a shower enclosure-you’ll ensure a brighter shine. This step isn’t critical, but it might help you clean anything you missed. If you’re in the mood to be ultra-thorough, you can rinse out the cloth, soak it in plain water, and go back over the plexiglass once more. Continue applying the cleaner and wiping it off in small sections until you’ve finished the entire surface. Once the cleaner has been applied, use a soft, lint-free microfiber cloth-or, in a pinch, a disposable diaper-to gently wipe the surface down, again being careful to make contact only with the portion of the surface that already has cleaner on it. (For an on-hand alternative, a solution of mild dish soap and water works well too.) 1 ( buy on Amazon), onto a one- or two-foot-square section of plexiglass. Once excess grime has been removed, spray a nonabrasive acrylic cleaner, such as Brillianize ( buy on Amazon) or Novus No. If you choose to go with the latter method, hold the blow dryer at a 45-degree angle several inches away from the plexiglass and run side-to-side down the surface. Instead, use air to clear the surface, either by blowing across the pane (close your eyes first!) or briefly using a blow dryer set to its coolest, lowest setting-never, ever heat plexiglass. Making direct, dry contact with surface particles using your hand or a cloth can actually grind them into the material itself. Begin by removing excess dust or dirt from the surface of the plexiglass, but not with your usual duster.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |